top of page

How To Calibrate Your Mel Meter

 

 

As part of a presentation for S.A. Paranormal Meet-ups Allen Tiller made this small video showing you how to calibrate your Mel Meter

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

How To Calibrate A Mel Meter

 

 

 

Step One: Hold the RECORD/ENTER button and HOLD/ESCAPE button at the same time

Turn power ON

 

When Mel Meter powers on you will see “S-On” on the display screen – keep holding two buttons

 

When two buttons are released, “0” (Zero) will appear on screen, Quickly push the UParrow button until it reaches “9”

 

Push ENTER

 

“CAL” will appear on the screen

 

Numbers will appear on the screen

 

Let the numbers stabilise

 

Step Two: press ENTER and then UP arrow

 

“200” will appear on the bottom of the screen

 

Let numbers stabilise again

 

Step Three: Press ENTER and UP Arrow for a third time

 

“300” will appear on the screen – this is the third and final calibration

 

press ENTER again

 

Then Power Down the meter

 

Calibration procedure now completed

 

Now turn on your Mel Meter, it should now be calibrated – if done properly should your Mel Meter should read 0.0

 

Only do this in a place where no EMF has been previously registered

 

 

 - Researched and written by Allen Tiller

- CEO S.A. Paranormal & Eidolon Paranormal

bottom of page